Differences

This shows you the differences between two versions of the page.

--- manual:joystick_graphics [2017/01/19 08:04] – rgoetz
+++ manual:joystick_graphics [2017/01/20 12:05] (current) – aerofly
@@ Line 1: / Line 1: @@
 ====== Joystick & graphics settings (PC) ======
-====== 1. Basic settings joystick  ======
+===== Basic settings joystick  =====
 Open “Settings” in the main menu and choose “Control” in the submenu.
 At the bottom of the new window you`ll find the recognized and usable USB-Joysticks. If you don`t find any entries please plug in your joystick once again and wait for a while. Select “Primary” to set up your joystick and proceed as follows:
 {{ :wiki:fs2_manual_en_002.jpg?450 |}}
@@ Line 62: / Line 61: @@
 {{ :wiki:fs2_steaml_en_021.jpg?600 |}}
-====== 2. Graphics settings ========
-Open the graphics settings from the main menu by clicking on “Settings” and “Graphics”.
-Use the graphics settings to optimize the flight simulator performance on your PC. For a smooth experience you will need an actual graphics card driver.
-If you ever have an issue in terms of graphics, please check your graphics card driver.
- {{ :wiki:fs2_manual_en_009.jpg?600 |}}
-===== Resolution =====
-Please disable any monitor zoom functions and set up the monitor resolution using this selection:
- {{ :wiki:fs2_manual_en_010a.jpg?600 |}}
-If you have a special resolution or encounter issue with a low frame rate then please use the “Window mode”. Now, you can scale the window size up to your full monitor size. This mode can help in case you encounter certain graphics card issues.
- {{ :wiki:fs2_manual_en_010b.jpg?600 |}}
-===== Limit frame rate =====
-Per default “vsync” is on. If you have any trouble obtaining a smooth performance you can limit the frame rate. The lowest is 120 FPS
- {{ :wiki:fs2_manual_en_010c.jpg?600 |}}
-===== Custom graphics settings =====
-To enable the individual graphics settings click on “custom” at the first line. The next 5 lines will be enabled. Now you can set up the texture quality or building density individually. To reset this settings simply click on one of the preset setups at the line “Graphics quality”.
- {{ :wiki:fs2_steaml_en_012.jpg?600 |}}