I have installed the Leo Bodnar board, but the control is jittery. There seems to be some constant little amount of fluctuating X-axis input.
I assume it's down to bad soldering by me maybe, could this be the cause?
Thanks.
I have installed the Leo Bodnar board, but the control is jittery. There seems to be some constant little amount of fluctuating X-axis input.
I assume it's down to bad soldering by me maybe, could this be the cause?
Thanks.
it could be the cause.
do you know the pot value in the yoke?
Maybe check with the board's datasheet. I think Leo recomendeds 100k to start with. .
it could be the cause.
do you know the pot value in the yoke?
Maybe check with the board's datasheet. I think Leo recomendeds 100k to start with. .
I actually have no idea what any of that means!
I do not understand the setup: pro flight yoke and leobodnar. I guess the yoke is directly connected via usb. So what is connected through the leobodnar board?
You disconnect the pitch and roll potentiometers and instead connect them to a Leo board, which means you no longer have the deadzone which is actually built in to the hardware of the yoke and can't be fixed via software.
Ok, i see. Thanks.
What jay 737 meant is the resistance of the pots in the yoke (e.g. 10k Ohm).
I dunno, on Youtube vids no settings or anything were changed to do with anything like that