Now that I'm testing the new releases I wanted to try out my hotas and G920 pedals for rudder. I have the issue that if I'm using the clutch pedal for left and gas pedal for right rudder, the center will be off in one direction, making the aircraft yaw and extreme rudder correction is needed to counter. It is also seen in the menu that the rudder position is confused after giving one axis as 'left' and the other as 'right', the center position being way off center (depending on which axis was given later).
In the Logitech setup program I can only combine the gas pedal with the brake pedal to make one single controller axis, the clutch does not have this option. But this is very inconvenient as even with that plastic piece removed from inside the brake pedal (to make it feel like braking with a brake servo failure), it's still much harder to push than the accelerator. I'll keep looking for a solution but any suggestions are welcome here.
Thanks in advance!
In the meantime I've found a workaround that can be used until IPACS comes out with a solution.
(Software option to combine two axes for rudder, pleeeease? ).
By using vJoy and UCR, one can combine the two separate input axis into a single one:
After that, the rudder can be added from the virtual joystick.