RC8 (Mac) does not start with Spektrum Wireless Simulation Dongle SPMWS1000 attached

  • RC8 (Mac version) will not start with SPMWS1000 already plugged into USB port. However, after starting RC8 without SPMWS1000 being plugged-in you can attach the SPMWS1000 and use it without problem.

    Any ideas about this ?

  • I just noticed this post. My Spektrum SPMWS1000 USB dongle has not been unplugged in a couple years. I upgraded from RC7 to RC8 with no problem.


    Is the dongle bound to your transmitter?

    I believe you can plug in after starting. Did it once with RC7.

    Lots of stick-time on the sim and in the air. Love building foam board planes. Wish the tools were here to build for the SIM.

  • After binding, how do you configure the Spectrum? What is the step by step procedure. I can't successfully perform the "move every stick, slider, and switch" routine. I always get a "no movement detected in (one of the switches)"? Then the program asks if I want to correct or accept the default setting. Neither approach leads to a successful transmitter to software configuration .