Problem with Cultivation

Chiefkoch · May 3, 2020 at 10:36 AM

Hi folks,

I have a problem with my custom cultivation. I used the Scenproc_Template V7 for generatione the toc-file. After starting aerofly fs 2 I get an "space elevator" with the height of around 45000 ft where normaly a tv tower sits. I tried to find this object in the toc-file with the coordinates and the floor level but no luck.

Maybe someone of our experts have an idea whats happend or could help me here please.

Best regrads,

Thomas

TomSimMuc · May 3, 2020 at 10:51 AM

Thomas, if you delete all lines in the spc file between

# CREATE POWER LINE TOWERS

# - Create Towers

and

#EXPORT DATA FOR USE WITH AEROFLY FS2

which removes the tower definitions, does it solve the problem?

Chiefkoch · May 3, 2020 at 11:04 AM

Hi Thomas,

thanks for your fast reply. I will check that directly. I also had a closer look in the toc-file and I found a lot of buildings (which are marked commercial) with decimal numbers at their floor definition. Is that okay?

TomSimMuc · May 3, 2020 at 11:10 AM

yes, as long as you do not find buildings with more the 40 floors...

Chiefkoch · May 3, 2020 at 11:14 AM

I have found the wrong entry (and a lot more with this number). More or less with luck. I deleted them an now it looks fine. Have someone an idea why this happens?

TomSimMuc · May 3, 2020 at 11:18 AM

Strange is, that there is a comma instead of a point in the floor count.

Chiefkoch · May 3, 2020 at 11:23 AM

I thought the same. Could this have something to do with . and , decimal separator of the OS?

ApfelFlieger · May 3, 2020 at 11:26 AM

It's been a while since I've looked for the cause. During "automatic cultivation" buildings became such high towers, if an object was entered as "tower" in the underlying OSM map, because it was e.g. an airport tower or observation tower of e.g. 10 - 20 m height. I did not pursue this any further due to time reasons.

Tschüss l Michael (III)