Kalibrierung bei Core Sender über euer USB Interface

  • Hallo,

    folgende Konfiguration:

    WIN10

    Sender: CORE POWERBOX SYSTEMS

    USB Interface über single cable (AEROFLY)

    Empfänger: Powerbox PBR-5S über PWM

    Nach mehrere Kalibierungsversuche sind noch immer bei den meisten Kanäle die Mittelstellungen verschoben. Im Sender ist alles OK und bei der Interface Kalibrierung im Aerofly wurden auch alle Schritte durchgeführt. Zudem sind alle Trimmer auf neutral. Das Höhenruder hat z.B. eine starke "Down" Tendenz um nur mal eines zu nennen. Was kann ich noch tun damit die Aerofly-Modelle "vernünftig" fliegen. Getestet habe ich Jets und Propellermaschinen in verschiedenen Größen. Ich bin am Ende meiner Weißheit nach nun mehr 5 Std. Suchen. Mein Fazit von Aerofly RC8 ist eher sehr ernüchternd. Schade..... :(

  • One thing to try is to go to your Win10 devices and printers. Select your controller and right click on it to get to a calibrate mode. After this, try calibrating it in RC8 again. Also, some controllers do not have very good centering to begin with. Try adding 20-30% expo (in your Tx and / or RC8 advanced controller setup).

    If there is a constant flight error maybe try editing the model to shift the CG accordingly (eg. If it has strong nose down, try moving the CG rearward. Good luck and cheers mate.

    Edit; I find that my Spektrum Interlink DX controller work perfectly with RC8 and highly recommend it.

    i9 13900K water cooled, RTX4090, Z790 MB w/wifi6e, 32Gb 6400 ram, 2x2TB SSD, 1000W PSU, Win 11, QPro w/Air Link, Vive Pro