Help with USB Receiver interface with Jeti DS12

  • Hi,

    I have just got the USB interface so I can plug in a receiver rather than use the USB cable. I am using a Jeti DS12 and an R5 receiver. I have gone through the set up instructions on this site. The receiver is bound to the radio on a new model. I have set channel 5 output for PPM. That is the pin for PPM on this receiver.

    When I go to configure it in Aerofly RC9 I can only calibrate the main sticks. It does not see the switches or sliders/knobs. I tried adding them in Functions assignment within the DS12 but that has made no difference.

    Any help really appreciated. Thanks. šŸ‘

    Everything works fine when I use the USB cable from DS12 to the computer.