Good points Stavka.
Unfortunately regarding altimeter adjustments AEFS4, just as the previous versions, appears not to model other than pure ISA atmosphere, so it's useless because the QNH will always be = QNE :-/
Maybe one day they can add some dynamic, or preferably online, weather, and then altimetry will have another taste and use...
Same applies to precipitation - AFAIK there is still no representation for precipitation in AEFS, nor the effects it has on aircraft operations, from visibility to runway contamination, etc...
Also, the flaps in all aircraft should work in steps. For example I have joystick buttons associated with open and close flaps, and they should open/close the flaps in steps and not full open/close.
This is very important in airliners where you have multiple flaps steps and your should progressively open them and not from full close to full open in one step.
Thank You!
That should already be the case. What controls did you assign to your flaps?
Have you defined press and release? This would then trigger twice inputs.
I use 2 buttons /one for flaps Up other for Flaps Down. Every time i do a press on each button, the flaps should move 1 step and not multiple steps as now.
For example B737 i can't get the flaps 5 or 40 because that jumps. Also in A320, it jumps from 2 to full without stop on 3.
It looks that it jumps 2 steps all the time.
Ok, and did you assign flaps in the multi-engine setup or just the default assignments?
If you have the same key for all of them, remove the once for twin jet and quad jet, only keep the default ones in essentials.
If you have the same key for all of them, remove the once for twin jet and quad jet, only keep the default ones in essentials.
Dumb question; how do you remove controller key or buttons settings with FS4? The only way I’ve found so far is to assign it to another working one and then follow the warning x’s and delete them. Thanks
Dumb question; how do you remove controller key or buttons settings with FS4? The only way I’ve found so far is to assign it to another working one and then follow the warning x’s and delete them. Thanks
Click on the button where you see it assigned, then press backspace.
Hello
Is there a way to get the time skip interface in VR (or maybe toggle time skip with a keybind)?
Other question: the performance is excellent in VR and cultivation is very well optimized but the clouds still seem to be taxing a lot. Is there a graphic option or config file tweak that can lower clouds quality for better fps?
The controls settings under simulation you can assign a key to time skip.
Hi
When flying, I notice that the lights is hardly visible at night on the ground.
In real flight ,however, these are very easy to recognise even at high altitudes.
Maybe it is possible to change this.
Many thanks
