Problems with Honeycomb Bravo Throttle Quadrant

I finally got one of these and I just hooked it up. In AFS 4 I have the axis' mapped and everything appears to be working, I'm setup for twin engine prop.

I load up the Dash 8, cold and and dark on the ramp at KSJC. I turn on the batteries, power the APU and the plane resets to the runway...? Then I load up the Baron 58, the condition axis does not move the controls in the cockpit.

Any ideas what could be going wrong? Paired with the Velocity One Flight Yoke.

EDIT: change mixture to condition

San Jose, KSJC I think, there's only 1 ramp spot there right by rwy 30