Is there a tutorial, or can someone explain how to performa an Autoland with A320? I have try, but doesn t seem it work, I don t see CAT3 ILS, and also it doesn t seem it work to engage both AP 1 and 2.
Autoland A320
-
Art69 -
August 5, 2022 at 9:09 AM -
Thread is marked as Resolved.
-
-
- Best Answer
- Official Post
aircraft:airbus_a320 [Aerofly FS Wiki]
You need to have a route programmed with an ILS approach or no route at all with auto-tuning enabled or manually entered ILS frequency and course.
When you press the APPR button on the autopilot it should arm LOC and G/S modes. Then you can perform the ILS approach and autoland if CAT III is shown.
-
Ok thank you. I will try again and let you know
https://www.aerofly.com/dokuwiki/doku.…s_a320#approach
You need to have a route programmed with an ILS approach or no route at all with auto-tuning enabled or manually entered ILS frequency and course.
When you press the APPR button on the autopilot it should arm LOC and G/S modes. Then you can perform the ILS approach and autoland if CAT III is shown.
Thank you. This work for me!
-