Hi, I just bought the saitek yoke and throttle quadrant, and I’ve set it up and binded everything, but when I use the throttle, it only moves the 2nd throttle and the 1st one wont move. As long as I have the throttle and yoke connected, the 1st throttle wont even move if I use the mouse… I may have binded something wrong as it’s my first time but I have the throttle 1 and throttle 2 binded to the same stick. Can I not do that? It shows it fine when I do it on the controls menu and moves both but not in the actual plane. Any help would be appreciated!
Saitek Yoke and Throttle Quadrant Throttle Problem
-
Jalice11 -
October 14, 2022 at 7:21 AM -
Thread is marked as Resolved.
-
-
- Official Post
Did you assign throttle 1 and 2 via the multi-engine menu?
-
Yes I did
-
- Official Post
Do you have any other axis assigned to the throttle 1? After disconnecting your quadrant you can remove any assignments to throttle in basic and multi-engine, then plug it back in and it should work.