DECELERATE while doing takeoff in A320/321

Good Day Ipacs

I am getting this “Decelerate” message while I am in the takeoff phase. This is preventing airplane to Speed up from 250 to 300 after 10000 ft check.

To demonstrate this issue:

I set the departure waypoint ICAO - departure - Sid and the star for the departure

Then set the Arrival waypoint ICAO - Arrival -Sid and star for the arrival.

why am I getting decelerate after 2nd Sid or 3rd Sid in the departure waypoint? Is it a bug?

Can you help me with this issue. I do the same procedure even in other study level Airbus like Toliss A320neo

Here’s the screenshot for the issue :

Quote from Jet-Pack (IPACS)

What route are you flying? Can you please also post a screenshot of the navigation menu? Thanks.

VOMM-VECC

sorry for the late. Because, it was midnight when you sent the reply.

Quote from AeroflyBro

This is strange... Maybe it's because you're flying higher than constraint altitude

But again, if it’s an alt constraint it should never say “Decelerate “ seems to be new for me.

I’ve flown in toliss a320neo. Unless I cross to “DECEL” waypoint, it wouldn’t tell me to “DECELERATE “.
Or am I doing wrong procedures?

Quote from Jet-Pack (IPACS)

Decelerate is shown after passing the top of descent when you get high on profile.

Agree to that but, for me the decelerate message comes while I am doing takeoff. I don’t understand in takeoff, it shouldn’t tell Decelerate unless I am in approach or in ils. That’s how I understood so far of that decelerate message. But, why only in Aerofly’s A320 I am getting this message while taking-off? That’s where my question comes.

Quote from Jet-Pack (IPACS)

What cruise altitude did you set?

35000ft. It’s in the screenshot, in cyan colour.

Airbus 333 is right, I need to compress the images to upload in the forum. It’s having a size limit. Either I should upload as low resolution or maybe convert to jpg for that.

Quote from Jet-Pack (IPACS)

The screenshot is super low resolution but I can already tell that it's not a screenshot of the MCDU, so the cruise altitude is not visible on the screenshot, just your selected altitude of the autopilot.

But, before departure I entered 350ft in my FMC. Or, should I select departure and arrival from the fmc? Not navigation page?

It showed there in fmc as 350 after a waypoint. Anyways, I’ll try again and let you know if this issue persists in my next flight.