Nose wheel behavior when no steering axis is assigned

calou95 · April 16, 2025 at 3:09 PM

Aerofly FS 4 - Nose wheel behavior when no steering axis is assigned

Hello,

Since the latest update of Aerofly FS 4, I’ve noticed a change in how the nose wheel behaves on the ground, especially with the A320.

Previously, if no axis was assigned to nose wheel steering (steering tiller), the rudder pedals would automatically control the nose wheel during taxi, which worked fine.

Now, when no steering axis is assigned, the nose wheel no longer reacts to rudder input. It appears to be stuck in a fully deflected position and the aircraft cannot turn on the ground. However, if I assign a slider or axis to the steering control, it works normally again.

I just wanted to report this observation in case this change was not intended.

Thank you for your work.

Best regards,

Jet-Pack (IPACS) · April 16, 2025 at 3:19 PM Official Post

Please check that you do not have a nose wheel tiller assigned in the categories: General, Twin Jet and Quad-Jet

calou95 · April 16, 2025 at 5:27 PM

I just wanted to let you know that the issue with the nose wheel was due to a configuration mistake on my side.

It was simply a wrong setting in the joystick configuration. Everything is working fine now.

Sorry for the confusion.

Best regards,