Using RC10 on Mac, is there a way to have virtual servos correspond exactly to the radio's output? (Zero mixing done by the simulator)
I specifically want to test my 7ch glider mixes, and get some muscle memory on switching between crow, butterfly and normal.
Additionally. also need to be able to set reflex and camber for all 4 wing control surfaces from the radio alone.
This cannot be done on the vanilla setup.
Binding to virtual servos to radio output?
-
- Official Post
Some of the gliders have a RAW setup which you can use for such purposes. You then should assign the controls for aileron 1, 2 and flap 1, 2 as well. These gliders have no mixers and you can program them in your own transmitter.
-
Butterfly, thermik, speed, compensation butterfly, snapflap.., dualrate, expo..., all from the original modell at the transmitter.
Freezers are from made a vid, it is VR quest 3.