Condition over not binding

Ronnicbubonnic · August 6, 2025 at 2:25 AM

hey IPACS Support for some reason I cannot get the bind. I set it up under mixture, but the levers don’t move. Any thought?

Jet-Pack (IPACS) · August 6, 2025 at 9:30 AM Official Post

What aircraft are you flying and did you assign it in the single engine or twin engine settings.

Ronnicbubonnic · August 6, 2025 at 11:20 AM

It’s the king Air. Twin prop

Ronnicbubonnic · August 7, 2025 at 2:11 PM

IPACS Support thanks for you email response as well, but it’s not a mapping issue, it’s that the lever do not move after binding.

Reinstalling to see if that changes anything

Jugac64 · August 7, 2025 at 2:15 PM

Binding hardware or keys?

Ronnicbubonnic · August 7, 2025 at 2:39 PM

Jugac64 binding hardware. I have two Saitek throttle quadrants. I have it setup throttle 1 throttle 2 prop speed 1 prop speed 2 mixture 1 mixture 2.

Jugac64 · August 7, 2025 at 2:59 PM

Thanks, I have one only and it is working well. Had been thinking in buying a second one, I like it very much. Will be following this discussion!

Ronnicbubonnic · August 7, 2025 at 3:06 PM

Do you have your right one configured for the condition lever?

I cannot get anything to bind for the condition lover and have to use my mouse, but I am fully in VR so it would be ideal if that could be bound

Jugac64 · August 7, 2025 at 3:44 PM

Let me check in the night and will confirm you (I hope to remeber this )

Jugac64 · August 8, 2025 at 6:09 AM

Which one you cannot bind?

Ronnicbubonnic · August 8, 2025 at 12:59 PM

Jugac64 i can bind all of them. But I have my two Saitek set up like this. For example in the king air, you have throttle 1 throttle 2 prop speed 1 prop speed 2 then fuel cut off condition levers.

but I can’t get the condition levers to bind. (Should be mixture in the sim)

Jugac64 · August 8, 2025 at 1:11 PM

Thanks , I just understood that I didn’t knew what the condition levers are. I did some research, to see. It seems that they are not supported to bind?

Overloaded · August 9, 2025 at 9:53 PM

Are turboprop levers more ‘air condition’ phase of flight engine management controls rather than being similar to piston engine mixture controls? They shouldn’t be crept up and down in tiny increments.

Tags