Problem with the calibration of the Thrustmaster TCA Airbus

1st Official Post

    Hello Guys,

    I am having an issue with my Thrustmaster TCA Airbus Quadrant in Aerofly FS 4.
    When I try to calibrate the quadrant (by clicking on the crosshair icon in the top right corner), as soon as I reach a detent on the thrust lever, it presses “okay,” which prevents me from reaching full detent. The same thing happens on the other side: I reach a detent and the window closes.
    This means I can't complete the calibration properly because, for example, I can't reach full deflection.

    Does anyone know how I can calibrate it correctly or what the problem could be?
    I want the throttle lever to work so that IDLE = 0% and TO/GA = 100% – and the detents (CLB, FLEX, TO/GA) are also recognized correctly.

    Thanks in advance!

    Best regards,
    Linus

    If I remember correctly, this topic has existed at least once in recent years. Therefore, the search function should also be able to help.

    Tschüss, Michael (🍎🚁)

    Configurations:

    - MacBook Pro (16", 2024); Chip: Apple M4 Max; actual macOS
    - Controllers: | WinWing: URSA MINOR-Fighter-Joystick R, EFIS-L & FCU & EFIS-R | Thrustmaster TCA AIRBUS EDITION: 2x Quadrant, 2x Quadrant Add-On | Pro-Flight-Trainer: PUMA X | Steelseries: Nimbus+

    - iPad (12,9", 4th Generation, RAM: 6 GB); actual iOS | Steelseries: Nimbus+

    Perhaps the topic below will help. I don't recall having to calibrate my TCA Airbus levers with Aerofly, all detents matched out of the box. I had to calibrate the Fenix A320 in MSFS


    Thread

    Unable to calibrate Thrustmaster Airbus throttle quadrant

    So I had an issue where I couldn't get the throttle lower than 20 % on my throttle quadrant, it wanted me to use the full range of the axis, that includes the beta range. So I went along trying to calibrate it, to no avail, the calibration menu exits as soon as I hit a detent.. then I tried to remove all axis and key assignments and try to calibrate again, again it exits the calibration menu. Is there some trick I need to do to make it work correctly ?
    Olsby
    January 16, 2023 at 5:03 PM