Hello everyone, how do I make a VOR approximation and that the L/DEV and V/DEV are shown? I've already tried everything and I can't, I've already selected a VOR arrival and that still doesn't come out
Approach vor
-
EduMunoz -
January 10, 2026 at 2:06 AM -
Thread is Resolved
-
- Official Post
Depending on if you fly the A320 family or A350/A380 there are differences, what do you use?
Plan for an RNAV approach in the navigation route.
Go to the assistance settings and turn off the auto-tuning assistant, that might help to disable auto-tuning to an ILS on the same runway.
-
Depending on if you fly the A320 family or A350/A380 there are differences, what do you use?
Plan for an RNAV approach in the navigation route.
Go to the assistance settings and turn off the auto-tuning assistant, that might help to disable auto-tuning to an ILS on the same runway.
A320 family, in the a350/380 this too work?
-
- Official Post
Did you press the approach button yet?
-
Did you press the approach button yet?
Yes, nothing happens when I press it, only blinks ils in the pdf
-
- Official Post
Can you please try it with an RNV approach instead of a VOR approach? I'm not sure if the VOR approaches work in managed mode yet, I don't think I fully implemented that.
-
Can you please try it with an RNV approach instead of a VOR approach? I'm not sure if the VOR approaches work in managed mode yet, I don't think I fully implemented that.
In RNAV only works V/DEV
-
Here you can see what it looks like (ILS flashing) when I press the app button, even without having ils frequencies in rad nav, even so I added the France of the vor to the VOR1 and VOR2 still does not show the V/DEV or L/DEV
I've flown that approach many times, something is not right with your FMA and ND. You should see FINAL APP at your position.
Make sure APPR is armed, LS, engaged, the NAVRAD PAGE (Does not) have the runways ILS freq tuned, but make sure the runway heading is in the RADNAV page.
You can enter a dummy freq into radnav page if the aircraft or assistance is auto-tuning. Do not put dummy frequency into the VOR section; it must be in the LS section, with the correct runway course.
-
On the smaller aircraft, the LS button needs to be switched off, (perhaps a bug?) A350 LS button needs to be engaged.
From memory, the A350 HUD also has a bug during RNAV approaches. It will also only display LDEV/VDEV if the LS is switched off.
-
- Official Post
The LS button needs to be on for the A350 and A380 and off for the A320 family. But that's just display, has no influence on autopilot to my knowledge.
