Hello Jan, I always have this problem in the simulator, in Boeing and airbus airplanes, a few hours ago I had this problem again, I’m doing something wrong?
Pressurization in Aerofly fs
-
Landing Elevation is around 12,000ft. I guess you fly around Peru a lot? I reported an issue about a year ago; the pressurization system is better off in manual when the destination airport is over a certain elevation. Its an intermittent fault though.
Passengers will be unconscious within a few minutes unless you get to a lower altitude
-
- Official Post
What is your destination airport?
I don't think I implemented the high field elevation function because I assumed we only have airports below 10,000ft.
In reality the aircraft should maintain pressurization at normal cabin altitude until the descent starts. For the high elevation destination it would then start increasing the cabin altitude instead of lowering it. But that requires special logic to not trigger the cabin altitude warning of course.
-
landing in SPJC with a elevation of 45ft
A screenshot of this scenario would be helpful for troubleshooting (Landing elev)
