Adjusting torbofan parameters...

jcomm · January 17, 2017 at 11:59 AM

The default A320 / 737 although they are set by default with some mid-high load, require a lot of throttle to get rolling, and to keep taxiing while, for those same GW values they should be able to taxi at ground idle.

Where in the tmd files should I look into in order to try to fine tune net thrust curves on ground and inflight ?

Jet-Pack (IPACS) · January 17, 2017 at 4:43 PM Official Post

The issue is not with the thrust I think its more the wheel friction which is too high at low speeds. But yes that is a known issue and I would like to taxi with idle thrust, too.
As far as I know there are no parameters for the turbofan, except the max. thrust, rotation inertia and N1 idle (which is already set correctly, or even on the high end...)

jcomm · January 17, 2017 at 6:49 PM

Ok!

Thx !