Flaps not animating

  • Hey everyone,


    I cannot seem to get my flaps working. I was wondering if anyone might see my issue.


    Input / output section;




    Hinged Body Graphics; (there are 4 flap parts)



    I also input this section under my flaps to see if this would bring them back to life. This was in the Robin TMD file.



    Hoping someone might find the issue.

  • You need a control_input called "InputFlaps" as well as the linear_interpolation "FlapsMapping" from another aircraft, e.g. the DR400.
    Only then do you read in the commands of your control devices and forward them to the actuator. (See in your first code block, Input "FlapsMapping.Output"... that is not defined in your tmd yet.


    Regards,
    Jan