Posts by SchwabeVR

    Hello,

    I'm currently flying the R22 and I'm quite satisfied. However I would like to put the tailrotor on my rudderpedals. I use the t16000m fcs flight pack. My problem is that I can only put the rowing motion in one direction at a time. Does anyone have a hint for me here?

    Greetings Sebastian

    Hallo Micha,

    Danke für deine Geduld :D

    Ich glaube ich warte bis es ein Programm gibt dir Dummies :D ich schaffe es nicht einmal in fset ein Vorschaubild zu sehen. Es kommt immer ein Fehler. Bzw. Im unteren Bereich lädt es etwas aber immer mit Fehlermeldungen.

    Gibt es denn dafür ein alternativ programm?

    Vielen Dank für deine Antwort ;)

    Ja das glaube ich die Datenmenge ist natürlich dann immens, wobei es ja vergleichbar ist, mit einer Auflösung von zl 18 bei X Plane.

    Das mit den Leveln bezieht du auf die Herstellung von den TFW Dateien mit inf2tfw? Sprich du lässt diese nicht automatisch herstellen?

    Ganz blöd gefragt, was wird mit den Leveln bezweckt bzw welche Auswirkungen haben die unterschiedlichen Level?

    Danke dir :)

    Hello,

    I am relatively new to Aerofly, so far I use X Plane as a simulator. So please forgive my perhaps stupid question :)

    To use your cultivation, I still have to follow the steps described in the Aerofly Wiki under Scenery Creation Part 1: Aerial Images? On this Link

    https://www.aerofly.com/dokuwiki/doku.…te_the_tfw_file

    And is it possible to generate them in a resolution 0? I am a pure VR VFR airplane and am therefore more likely on the ground. or is there any other good instructions or video in German :)

    Thanks again how much time and work you put into the project that is really great :)

    greetings

    Sebastian