Posts by jaylynch
-
-
After binding, how do you configure the Spectrum? What is the step by step procedure. I can't successfully perform the "move every stick, slider, and switch" routine. I always get a "no movement detected in (one of the switches)"? Then the program asks if I want to correct or accept the default setting. Neither approach leads to a successful transmitter to software configuration .
-
any suggestions are appreciated.
what is the first step to configure the software and the DX8?
-
I haven't been able to configure using the WS1000 on a Mac and DX8 radio.
Calibration - moving the controller sticks, switches does not result in successful calibration. I get message saying that some channels are not complete; no movement detected in channels marked red. When I’m unable to correct .
After calibration, controls are not working; no throttle or control surfaces response.The DX8 is recognized by the software under the controller menu selection.
What is the step by step procedure used to setup the WS1000 and Spektrum transmitter?
Thank you.
Jay Lynch