Posts by SopwithCamel

Hi Jan,

Thanks for all your suggestions on how to get these planes flying better. However, I am surprised that the default settings aren't suitable.

I finally have the Miss Wind set up nicely now after increasing the drag a little and turning the engine brake off. Allowing the two propellers of the contra drive to spin freely really helps to slow this plane down in the way I would expect.

Regards,
Jonathan

Hi Jan,

Thanks for that information.

Is the idle engine percent set by the I0 variable under engineelectric?

Regards,
Jonathan

Hi Jan,

Thanks for your prompt reply to my post.

I've checked the TMD file, and the terms fuselage and throttle are mentioned many times. Which lines exactly would I have to edit to change the fuselage drag and idle throttle settings? And what values would you recommend?

Regards,
Jonathan

Hi,

I started using Aerofly RC 10 a few days ago, and I've been surprised with the way several of the aircraft with the default setup will glide on for ages after the throttle has been reduced to zero. Particularly with the Miss Wind plane, I can turn the motor off, glide all the way down the strip and turn to come back down the runway, and the plane still behaves like it has approximately 30% throttle on when I finally try to touch down on the runway. The plane is still moving so fast that even then I have trouble landing. The PT-40 is also quite unrealistic in this regard, but since it has an IC engine, I can practically fix the problem by reducing the engine idle to 0.5.

The Pitts Python, SU-29, and Adrenaline 120 don't have this problem at all. They just slow down like I would expect them to.

I've tried changing a few of the airfoil settings with limited success, as each of these affects the model in other ways as well.

Is there some kind of overall simulator setting or individual model parameters that I can change to fix this?

Kind regards,
Jonathan