aircraft:ec135_helicopter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
aircraft:ec135_helicopter [2020/10/09 10:48] – [Cyclic] jh | aircraft:ec135_helicopter [2020/10/09 11:07] – [Engine Main and FADEC Switches] jh | ||
---|---|---|---|
Line 158: | Line 158: | ||
- | ==== Engine Main Switches ==== | + | ==== Engine Main and FADEC Switches ==== |
In the front panel in the lower left center section you can find the engine 1 and 2 MAIN switches, labeled OFF, IDLE and FLIGHT as well as the FADEC switches. | In the front panel in the lower left center section you can find the engine 1 and 2 MAIN switches, labeled OFF, IDLE and FLIGHT as well as the FADEC switches. | ||
Line 173: | Line 173: | ||
{{ : | {{ : | ||
+ | |||
+ | ==== MCDU ==== | ||
+ | |||
+ | Navigation and communication frequencies can be changed with the Multifunction Control Display Unit (MCDU). | ||
+ | |||
+ | * Push the FREQ button to access the radio page. It should already be displayed per default. | ||
+ | |||
+ | As an example we will now tune a frequency for the NAV 1 receiver. All other frequencies are tuned in a similar fashion. | ||
+ | |||
+ | * Enter the frequency you want to tune with the number-keypad. The entry appears in the scratchpad at the bottom of the MCDU screen. | ||
+ | * Press the line select key on the right where you want to enter the frequency. This will set the standby frequency of the receiver. | ||
+ | * Transfer the frequency to the active side on the left by pushing the associated line select key on the left hand side, in this case "<- NAV1" | ||
+ | |||
+ | {{ : | ||
---- | ---- |
aircraft/ec135_helicopter.txt · Last modified: 2023/11/08 20:58 by jh