Differences

This shows you the differences between two versions of the page.

--- aircraft:learjet_45 [2018/07/20 16:28] – [Before Taxi] jh
+++ aircraft:learjet_45 [2018/07/20 17:54] – jh
@@ Line 550: / Line 550: @@
   * Move your mouse cursor over the base of the spoiler lever or over the slot in the throttle quadrant where the spoiler lever shaft cuts through and rotate the mouse wheel over that area to extend the spoilers
 or
-  * Point the mouse cursor on the spoiler lever, hold down the left mouse button and drag the lever aft.
+  * Point the mouse cursor at the spoiler lever tip, hold down the left mouse button and drag the lever aft.
 The spoilers extension is visible on the Engine Indication and Crew Alerting System display (EICAS) in the Crew Alerting System (CAS) as text info "SPOILERS EXT" as well as in the spoiler position indicator.
@@ Line 572: / Line 572: @@
 **Taxi Lights On**
-  * On the LIGHTS panel, mouse over the the three state landing/taxi switch ("L LDG" and "TAXI" written next to it) and rotate your mouse wheel to set the switch to the middle "TAXI" position. You can also left or right click the switch to manipulate the state
+  * On the LIGHTS panel, mouse over the the three state landing/taxi switch ("L LDG" and "TAXI" written next to it) and rotate your mouse wheel to set the switch to the middle "TAXI" position.
 \\
@@ Line 586: / Line 586: @@
 or
   * Click the parking brake handle
+or
+  * Point at the parking brake handle and hold down the left mouse button and move the mouse to drag it.
 \\
@@ Line 657: / Line 659: @@
 {{ :wiki:lj45_pitch_trim.jpg?350|}}
-To manually adjust the pitch trim setting
+To manually adjust the pitch trim setting we can either
-  * mouse over the PITCH TRIM switch and rotate the mouse wheel to set the correct trim
+  * use the assigned pitch trim control on our input device
+or with the control in the pedestal. But to use the control in the pedestal we first have to set the pitch trim switch to the SEC (secondary) position
+  * mouse over the PITCH TRIM PRI/OFF/SEC switch and rotate the mouse wheel to set the switch to the aft "SEC" position
+  * mouse over the black PITCH TRIM SEC rocker on the left and rotate the mouse wheel to set the correct trim
-or use your assigned pitch trim input to make the changes.
 **Note** - This panel is located in the pedestal, near the pilot seat and aft of the FMS devices.