Differences

This shows you the differences between two versions of the page.

--- aircraft:learjet_45 [2018/07/20 16:32] – [Before Taxi] jh
+++ aircraft:learjet_45 [2018/07/20 17:54] – jh
@@ Line 572: / Line 572: @@
 **Taxi Lights On**
-  * On the LIGHTS panel, mouse over the the three state landing/taxi switch ("L LDG" and "TAXI" written next to it) and rotate your mouse wheel to set the switch to the middle "TAXI" position. You can also left or right click the switch to manipulate the state
+  * On the LIGHTS panel, mouse over the the three state landing/taxi switch ("L LDG" and "TAXI" written next to it) and rotate your mouse wheel to set the switch to the middle "TAXI" position.
 \\
@@ Line 659: / Line 659: @@
 {{ :wiki:lj45_pitch_trim.jpg?350|}}
-To manually adjust the pitch trim setting
+To manually adjust the pitch trim setting we can either
-  * mouse over the PITCH TRIM switch and rotate the mouse wheel to set the correct trim
+  * use the assigned pitch trim control on our input device
+or with the control in the pedestal. But to use the control in the pedestal we first have to set the pitch trim switch to the SEC (secondary) position
+  * mouse over the PITCH TRIM PRI/OFF/SEC switch and rotate the mouse wheel to set the switch to the aft "SEC" position
+  * mouse over the black PITCH TRIM SEC rocker on the left and rotate the mouse wheel to set the correct trim
-or use your assigned pitch trim input to make the changes.
 **Note** - This panel is located in the pedestal, near the pilot seat and aft of the FMS devices.