Differences

This shows you the differences between two versions of the page.

--- aircraft:tmd:actuators [2019/07/20 17:58] – [servocyclic] jh
+++ aircraft:tmd:actuators [2019/07/20 18:05] – [Actuators and Servos] jh
@@ Line 3: / Line 3: @@
 The actuators in Aerofly FS 2 can simulate the delay between control input and physical deflections.
+**Naming Convention**
+To differentiate between mechanical controls and electric or hydraulic actuators we add "**Servo**" in front of the object.
 ==== servoclassic ====
@@ Line 85: / Line 88: @@
 ==== electrical_actuator ====
+The electrical_actuator simulates an electric motor to move the flaps for example. It requires an [[aircraft:tmd:electrical|electrical network]] to receive electrical power.
+''Speed'' is the maximum speed up and down (in case of the flaps the +0.07 is for flaps down, towards greater angle and the -0.07 would be the flap retraction speed, which can differ).
+''Position'' is the initial position of the actuator when the aircraft is loaded.
+''Input'' is the target position, ''InputEnable'' is a cut off, ''InputVoltage'' and ''AddLoad'' are the connections to the electrical bus network, the ''MinimumVoltage'' and ''RatedCurrent'' are electrical properties.
 <code>            <[electrical_actuator][ServoFlaps][]
@@ Line 94: / Line 105: @@
                 <[float64][RatedCurrent][10.0]>
                 <[float64][Speed][ -0.07 0.07 ]>
-                <[float64][Position][1.0]>
+                <[float64][Position][0.0]>
             >
 </code>