manual:controller
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
manual:controller [2017/01/20 12:50] – aerofly | manual:controller [2022/07/07 11:14] (current) – removed jh | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Controller setup (PC version) ====== | ||
- | |||
- | Aerofly FS 2 supports a wide variety of joysticks and gamepads from various manufacturers. For most of these controllers Aerofly FS 2 also features a default assignment. However, Aerofly FS 2 is fully customizable, | ||
- | |||
- | Open ' | ||
- | At the bottom of the new window you'll find the recognized joysticks, gamepads and other compatible controllers. If you don't see a connected controller, please plug it in once again and wait for a while. Select ' | ||
- | |||
- | {{ : | ||
- | |||
- | ===== Assigning controller axes to functions ===== | ||
- | * Click left in the mid field of the function you want to program the controller | ||
- | * Follow the displayed instructions to move e.g. the rudder to the right or the throttle to maximum | ||
- | * Check your setting by observing the movement of the white bar | ||
- | * The assignment will be saved automatically | ||
- | |||
- | ===== Deleting an assignment for a function ===== | ||
- | If you want to delete an assignment click once again on the mid bar of the respective function and press the ' | ||
- | |||
- | ===== Assigning joystick buttons or keys ===== | ||
- | Proceed as follows to program functions such as flaps or brakes: | ||
- | * Click left in the smaller fields at the function you want to program. | ||
- | * Press the button on the joystick or keyboard for the functions you wish to program. | ||
- | * Please note that many functions need two buttons or keys to increase or decrease | ||
- | * The settings will be saved automatically | ||
- | |||
- | ===== Separate joystick and rudder pedals ===== | ||
- | {{ : | ||
- | If you want to use separate rudder pedals please proceed as follows: | ||
- | |||
- | * Plug in the joystick and pedals directly to two different USB plugs at your computer | ||
- | * If you want to use a USB hub please use an active one with your own power supply | ||
- | * Wait until windows has installed the USB driver for any USB devices you want to use | ||
- | * Start aerofly FS2 and open “Settings” / “Control” (image) | ||
- | * If you see all USB devices at the bottom, start programing the single functions: | ||
- | * Click the throttle function and move the throttle on the joystick to full power | ||
- | * Click the elevator (aileron) function and move the joystick down (right) | ||
- | * Click the rudder function and move the rudder pedals to the right | ||
- | * Open the folder to see both wheel brakes (left and right) | ||
- | * All settings will be saved automatically | ||
- | |||
- | ===== Troubleshooting joystick and other USB devices ===== | ||
- | If you have any problems in programming the buttons or axis on your USB device then please click on the displayed USB device button at the ' | ||
- | |||
- | {{ : | ||
- | |||
- | ===== Joystick calibration ===== | ||
- | Most joysticks and gamepads should be calibrated by default. However if you connected joystick is not properly calibrated, you can do so in the ' | ||
- | |||
- | {{ : | ||