Differences

This shows you the differences between two versions of the page.

--- manual:virtual_reality [2018/02/26 19:50] – jf
+++ manual:virtual_reality [2018/02/27 01:45] – [Physical Controls] jf
@@ Line 13: / Line 13: @@
 Within the **Virtual Reality** menu you will find the following settings. See the descriptions below to learn what each setting does.
-{{:wiki:vrr.png?700|}}
+{{:wiki:vrmenu1.png?700|}}
 ==== Scale Factor ====
@@ Line 27: / Line 27: @@
 Setting this feature to "ON" will enable lens flare effect.
-==== Show Hand Controllers During Simulation ====
+==== Transparency of your virtual hands ====
-For users that wish to use motion controllers in Aerofly FS 2 you must turn this setting to **ON**
+Use this setting to adjust how transparent you want your virtual hands.
-**Important Note** - If you plan on using motion control failure to set this to ON will result in not seeing your virtual hands during simulation.
-If you plan on only using Aerofly FS 2 in 2D mode there is no need to have this setting set to on however enabling it makes no difference in 2D.
 ==== Show Native View on Main Monitor ====
@@ Line 168: / Line 164: @@
 *The view pan function can be used to customize your view. This function is available in only certain views.
-**Rudder Control and Brakes**
+**Rudder Control, Throttle, and Brakes**
 {{:wiki:touchbrake.jpg?300|}}
 {{:wiki:vivebrake.jpg?300|}}
-^Function     ^Button           ^Input        ^
+^Function     ^Button              ^Input              ^
-|Brakes       |Left Analog Down |Pressure Sensitive |
+|Brakes       |Left Analog Down    |Pressure Sensitive |
-|Raw (Rudder) |Left Analog L/R  |Pressure Sensitive |
+|Raw (Rudder) |Left Analog L/R     |Pressure Sensitive |
+|Throttle     |Left Analog U/D FULL|Pressure Sensitive |
+**Note** - Throttle control is bound to the analog stick up and down function. The brakes are also bound to down. If you don't pull down fully on the stick the throttle will not be affected.
 **Yoke/Stick Control**