sdk:geoconvert
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
sdk:geoconvert [2017/07/22 14:55] – aerofly | sdk:geoconvert [2017/07/22 17:18] – aerofly | ||
---|---|---|---|
Line 7: | Line 7: | ||
====How Aerofly renders aerial images==== | ====How Aerofly renders aerial images==== | ||
Aerofly FS 2 uses textures with a varying coverage to render the earth. For this Aerofly FS 2 uses a level technique with different resolutions per level to render aerial images. At the base there is level 0. Level 0 consists of a single square image that covers the whole earth. This image would be used if viewing earth from very far away. Next is level 1. Level 1 consists of 2x2 images covering the whole earth. Then for level 2 we have 4x4 textures and so on. Aerofly FS 2 currently supports the maximum level of 15 which gives you roughly a resolution of 50cm per pixel. | Aerofly FS 2 uses textures with a varying coverage to render the earth. For this Aerofly FS 2 uses a level technique with different resolutions per level to render aerial images. At the base there is level 0. Level 0 consists of a single square image that covers the whole earth. This image would be used if viewing earth from very far away. Next is level 1. Level 1 consists of 2x2 images covering the whole earth. Then for level 2 we have 4x4 textures and so on. Aerofly FS 2 currently supports the maximum level of 15 which gives you roughly a resolution of 50cm per pixel. | ||
- | Its recommended that your aerial images are converted to level 9, 11, 12, 13 and 14 to give a good coverage. Level 14 corresponds to roughly | + | |
+ | Its recommended that your aerial images are converted to level 9, 11, 12, 13 and 14 to give a good coverage. Level 14 corresponds to roughly | ||
+ | |||
+ | ====Installation==== | ||
+ | After you have downloaded the GeoConvert tool, unzip the ZIP file to any place you like, prefereably to a harddisc with enough free storage. | ||
+ | |||
+ | Here is the folder structure of the tool | ||
+ | <code cpp> | ||
+ | aerofly_fs_2_geoconvert | ||
+ | input_aerial_images | ||
+ | scenery | ||
+ | images | ||
+ | images_raw | ||
+ | shader_dx11 | ||
+ | texture | ||
+ | aerofly_fs_2_geoconvert.exe | ||
+ | </ | ||
+ | |||
+ | GeoConvert cannot be started by its own, it must be called with a configuration file that tells GeoConvert what region it should create Aerofly FS 2 compatible aerial images. You can either open a console or the Windows Powershell or create a small batch file right next to the aerofly_fs_2_geoconvert.exe executable. Here is an example | ||
+ | < | ||
+ | .\aerofly_fs_2_geoconvert.exe your_config_file.tmc | ||
+ | </ | ||
====General steps==== | ====General steps==== |
sdk/geoconvert.txt · Last modified: 2017/11/12 17:30 by jh