This is an old revision of the document!
This tutorial will show you how to work with some advanced techniques; we will seamlessly add an adjacent area and use the 'images_raw' folder for further editing. Note: To keep this tutorial project manageable, we will concentrate on only 4 images.
1. In the below photo you will see the basic situation (coordinates derived from .INF files).
2. Now let us run our first geoconvert. The longitude value will be set to -122.50. Note: This is completely independent from the image dimensions. Additionally we will activate the images_raw option. The folder must exist before conversion.
As you can see, the level 9 consists only of 2 tiles. Since our images do not cover the Aerofly level 9 tiles completely, there are masks for the tiles. There are no masks at the right side along longitude -122.50. The images folder contains the same content just in the generic Aerofly file format .TTC.
3. Now let’s run the second geoconvert. The longitude border is again -122.50.
4. Now let’s copy this content into the folder of our first conversion. We will start with the images_raw content and get a message that duplicate files exist.
Since we are able to view the .PNG files, we can compare them. In this case all 11 files are identical. We overwrite them and repeat the copy process for the images folder as well.
5. From within Aerofly FS2, select the location menu and move to the NW corner of the USA. You will see the coverage of our four images, and you will not see the boundary of our 2 conversions.
Note: You have noticed that the sea surface is missing in the left part of our images You can use the alpha blending technique to eliminate this by following the Alpha Blending Tutorial. This should be done before running the geoconvert tool.
In this example we will show the comparison of exact frame, outer frame, and inner frame in the TMC file.
But, watch the frame border on the right side (east side):
Our image ends after about half the tile and a mask for the right part has been created. We can avoid this mask by having ‘enough’ imagery outside of our frame. Then the tile would have been filled completely by the imagery. So if you plan to do adjacent areas, a massive overlap of imagery is recommended.
Attention: Lower levels of aerofly tiles cover a large area. In our example a single level 9 tile covers about 52nm E-W x 39nm N-S (Whidbey area). If you convert a tiny area, it may fill only a small fraction of this tile. If you convert an adjacent tiny area, it may fill another fraction of this tile.
Solution: Do not convert low levels for very small areas or use a massive overlap of your aerial imagery.