sdk:scenery_creation
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
sdk:scenery_creation [2017/07/16 17:22] – [Create the TFW file] jf | sdk:scenery_creation [2017/07/17 15:43] – [Addendum] jf | ||
---|---|---|---|
Line 17: | Line 17: | ||
* **Aerofly FS2 simulator - Must be installed** | * **Aerofly FS2 simulator - Must be installed** | ||
- | * **Aerofly FS2 SDK package - Download it from: [[https:// | + | * **Aerofly FS2 SDK Tools package - Download it from: [[https:// |
* **FS Earth Tiles (FSET) - Download it from: [[http:// | * **FS Earth Tiles (FSET) - Download it from: [[http:// | ||
* **FSEarthTiles.ini - Download it from: [[https:// | * **FSEarthTiles.ini - Download it from: [[https:// | ||
Line 119: | Line 119: | ||
In the below image, the parameter lonlat_min specifies the NW corner, the parameter lonlat_max specifies the SE corner. | In the below image, the parameter lonlat_min specifies the NW corner, the parameter lonlat_max specifies the SE corner. | ||
- | {{:wiki:showing_coordinates.jpg?700|}} | + | {{:wiki:tmc_file.jpg?700|}} |
- | * The same coordinates should be repeated for each level as seen in the above **.TMC** file. You can manually add levels up to level 14, normally beginning at level 9. This is your resolution at different flight levels seen in the sim. | + | * The same coordinates should be repeated for each level as seen in the above **.TMC** file. You can manually add levels up to level 14, normally beginning at level 9. This is your resolution at different flight levels seen in the sim. **Note**- The coordinates entered into the TMC file should be two digits after the decimal to avoid conversion issues. |
====Section Alpha Blending (Optional)==== | ====Section Alpha Blending (Optional)==== | ||
Line 241: | Line 241: | ||
With this method you can also precisely add adjacent areas, even from overlapping aerial images. | With this method you can also precisely add adjacent areas, even from overlapping aerial images. | ||
- | **Note-**this tutorial was written by Rodeo and edited by Jeff. | ||
sdk/scenery_creation.txt · Last modified: 2017/11/12 17:54 by jh