Differences

This shows you the differences between two versions of the page.

--- sdk:scenery_creation [2017/07/16 17:22] – [Create the TFW file] jf
+++ sdk:scenery_creation [2017/11/12 17:54] (current) – [Find an Area] jh
@@ Line 17: / Line 17: @@
    * **Aerofly FS2 simulator - Must be installed**
-   * **Aerofly FS2 SDK package - Download it from: [[https://www.aerofly.com/aerofly_fs_2/sdk/|here]]**
+   * **Aerofly FS2 SDK Tools package - Download it from: [[https://www.aerofly.com/community/filebase/index.php?category-file-list/3-aerofly-fs-2-sdk/|here]]**
    * **FS Earth Tiles (FSET) - Download it from: [[http://www.f-bmpl.com/index.php/faites-le-vous-meme/209-2-installation-de-fsearthtiles-1-3|here]]**
    * **FSEarthTiles.ini - Download it from: [[https://1drv.ms/u/s%21Av7euqX9-qNYiJZV6FifunXaO4EBYQ|here]]**
@@ Line 25: / Line 25: @@
 ====Find an Area====
-Once you know which scenery area that you wish to add to Aerofly FS2, visit the site: http://en.mygeoposition.com/]]
+Once you know which scenery area that you wish to add to Aerofly FS2, visit the site: http://en.mygeoposition.com/
    * Search for the name or move the map to your position.
@@ Line 119: / Line 119: @@
 In the below image, the parameter lonlat_min specifies the NW corner, the parameter lonlat_max specifies the SE corner.
-{{:wiki:showing_coordinates.jpg?700|}}
+{{:wiki:tmc_file.jpg?700|}}
-   * The  same coordinates should be repeated for each level as seen in the above **.TMC** file. You can manually add levels up to level 14, normally beginning at level 9. This is your resolution at different flight levels seen in the sim.
+   * The  same coordinates should be repeated for each level as seen in the above **.TMC** file. You can manually add levels up to level 14, normally beginning at level 9. This is your resolution at different flight levels seen in the sim. **Note**- The coordinates entered into the TMC file should be two digits after the decimal to avoid conversion issues.
 ====Section Alpha Blending (Optional)====
@@ Line 228: / Line 228: @@
 The frame shows the area coverage of FSET. If we reduce the size in the GeoConvert TMC definition, we can avoid masking and reduce calculation power. You can try to set straight coordinates of degrees and minutes.
-{{:wiki:mociac.jpg?600|}}
+{{:wiki:mociac2.jpg?600|}}
 {{:wiki:mosiac2.jpg?600|}}
@@ Line 241: / Line 241: @@
 With this method you can also precisely add adjacent areas, even from overlapping aerial images.
-**Note-**this tutorial was written by Rodeo and edited by Jeff.