Unable to bind controller movement to axis

  • Hello All-


    I just got a set of Puma flight controls and I can't seem to get it to bind the controls to the correct axises. I've calibrated the controls, and all of the different controls show up as moving bars on the calibration screen. However when I go to set the pedals as the rudder control, I click on the center of the bar and move the pedals, there is no acknowledgement from the software that I am moving one of the controls. It will let me bind buttons but not control axises.


    I feel like I am missing something super simple, but I just can't quite put my finger on it.


    I hope this was clear enough... Really looking forward to getting this working!