Posts by Ortac

Currently there is no active control loading solution for Aerofly. Ingremio were going to make a control loaded cockpit for the Extra 300, but that project seems to have stalled.

I wish I could use Brunner CLS yoke and rudder pedals. Brunner support X Plane, P3D, MSFS, and DCS but not Aerofly. Brunner seem to think Aerofly does not have the market share to be worth the effort, but FS3 could change that. Please contact Brunner and try to persuade them to support Aerofly FS3.

Also the next gen VR simulators must optimally support the next gen VR headsets such as new developments by Pimax, including ultraleap hand tracking.

Recently installed the Just Flight Hawk T1 in Aerofly. This flight model has a bad adverse yaw problem. Aileron adverse yaw effect is more like a glider or Tiger Moth than a jet. According to a friend who flew the type as a QFI there is no adverse yaw in the real aircraft.

With the X plane version I managed to correct the fault in Plane Maker. Does anybody know how to adjust adverse yaw effect in Aerofly?

Quote from IZ0JUB

Whats the name of the airfield please?

Glenforsa

I took the photo in August from the hotel balcony

ApfelFlieger has an airfield for Glenforsa but the runway is tarmac when it should be grass.

And X-plane / Orbx

Screenshot

Fantastic

I can't get the mixture control to work in the Extra 330 LX. The knob moves correctly but has no effect on fuel flow and does not shut down the engine at full lean.

AFIK in X-Plane the ability to link a second computer as image generator was intended to facilitate multi projector or multi screen visual displays for physical cockpits. However this ability also makes possible multiple VR headsets.

In the future we would like to have a two seat (tandem) VR cockpit with dual controls for training. This would need two VR headsets for two pilots in the same aircraft.

With X-Plane this is possible by linking two computers: one master computer for the flight model and first VR headset, the second computer acting as image generator for the second VR headset.

Is it possible to have two VR headsets with Aerofly FS2?

The atmosphere is ISA and can't be changed, but the altimeter baro knobs in the aircraft do work using the mouse.

For aerobatics we need to set QFE so the altimeter reads height above the airfield. I would like to be able to assign the altimeter baro knob to a physical knob which requires button assignments in controller setup. All the other navigation and autopilot knobs are assignable, but not the altimeter knob.

How can I bind buttons or keys to the altimeter baro setting knob? I can't find this in controller sittings.

Quote from flightxtreme

I know I can show a slider to replay a flight in Aerofly FS 2. This is fine but I like to save the data on disk for further analytics. (Or replay on a different day.)

Any update on when this might be available? We need to be able to save and replay demonstrations.

Thanks for the reply. I sent a e mail to flightextreme to ask about this.

Also how can I put a sequence diagram (PDF file) in the cockpit in VR?

Where is the repaint kit for the Extra 330 LX ? I can't find it under SDK downloads.