manual:graphics
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
manual:graphics [2017/01/27 01:50] – jf | manual:graphics [2017/01/28 04:02] – jf | ||
---|---|---|---|
Line 32: | Line 32: | ||
The **Graphics Quality** setting can provide you with specific pre defined quality settings (Low, Medium, High, Ultra), or allow for you to customize your settings field by field (Custom) | The **Graphics Quality** setting can provide you with specific pre defined quality settings (Low, Medium, High, Ultra), or allow for you to customize your settings field by field (Custom) | ||
To enable the individual graphics settings click on “custom”, | To enable the individual graphics settings click on “custom”, | ||
+ | |||
+ | ===== System Requirements ===== | ||
+ | |||
+ | ==== Minimum ==== | ||
+ | **OS:** Windows 7, Windows 8, Windows 10 (64 Bit Required) | ||
+ | **Processor: | ||
+ | **Memory:** 4 GB RAM | ||
+ | **Graphics: | ||
+ | **Storage: | ||
+ | **Sound Card:** DirectX Compatible soundcard | ||
+ | |||
+ | ==== Recommended ==== | ||
+ | **OS:** Windows 10 (64 Bit Required) | ||
+ | **Processor: | ||
+ | **Memory:** 16 GB RAM | ||
+ | **Graphics: | ||
+ | **Storage: | ||
+ | **Sound Card:** DirectX Compatible soundcard | ||
+ | |||
+ | In most circumstances you should achieve framerates over 100 in configurations that meet the recommended system requirements. | ||
+ | |||
+ | |||
+ | ===== Systems: Quality Vs. Performance in VR Guide ===== | ||
+ | |||
+ | Want ULTRA quality settings, with smooth performance, | ||
+ | |||
+ | ==== VR: Recommended Configuration for ULTRA Settings ==== | ||
+ | **OS:** Windows 8, 10 64 Bit | ||
+ | **Processor: | ||
+ | **Memory:** 16 GB RAM | ||
+ | **Graphics: | ||
+ | **Render Scale Factor:** 1.60 **Note:** - This setting can be found under **Settings/ | ||
+ | **Limit Frame Rate:** VSync OFF **Note:** This setting can be found under **Settings/ | ||
+ | Oculus Rift or HTC Vive. | ||
+ | |||
+ | **Note** - If stuttering occurs in densely populated areas, reducing the **Building Density** will greatly inprove performance with limited graphical degradation. | ||
+ | |||
+ | ==== VR: Ultimate Configuration for ULTRA Settings ==== | ||
+ | **OS:** Windows 10 64 Bit | ||
+ | **Processor: | ||
+ | **Memory:** 32 GB RAM | ||
+ | **Graphics: | ||
+ | **Render Scale Factor:** 2.00 **Note:** - This setting can be found under **Settings/ | ||
+ | **Limit Frame Rate:** VSync OFF **Note:** This setting can be found under **Settings/ | ||
+ | Oculus Rift or HTC Vive. | ||
+ | |||
+ | **Note** - Systems with less than the above configurations can also run Aerofly FS 2 in VR by reducing some graphic settings. Most reductions of graphic settings will not take away from your VR experience. | ||
+ | |||
+ | **Note** - If you experience flashing shadows while in VR, reducing the **Shadow Quality** to MEDIUM will reduce the distance that the building shadows are seen but not reduce the overall quality of the shadows rendered. This may improve your VR experience in Aerofly FS 2. | ||
+ | |||