Differences

This shows you the differences between two versions of the page.

--- manual:virtual_reality [2018/02/24 18:16] – jf
+++ manual:virtual_reality [2018/02/27 01:40] – [Physical Controls] jf
@@ Line 13: / Line 13: @@
 Within the **Virtual Reality** menu you will find the following settings. See the descriptions below to learn what each setting does.
-{{:wiki:vrr.png?700|}}
+{{:wiki:vrmenu1.png?700|}}
 ==== Scale Factor ====
@@ Line 27: / Line 27: @@
 Setting this feature to "ON" will enable lens flare effect.
-==== Show Hand Controllers During Simulation ====
+==== Transparency of your virtual hands ====
-For users that wish to use motion controllers in Aerofly FS 2 you must turn this setting to **ON**
+Use this setting to adjust how transparent you want your virtual hands.
-**Important Note** - If you plan on using motion control failure to set this to ON will result in not seeing your virtual hands during simulation.
-If you plan on only using Aerofly FS 2 in 2D mode there is no need to have this setting set to on however enabling it makes no difference in 2D.
 ==== Show Native View on Main Monitor ====
@@ Line 145: / Line 141: @@
 {{:wiki:menubutton.jpg?300|}}
-{{:wiki:vive_menu.jpg?300|}}
+{{:wiki:vcont.jpg?300|}}
 ^Function         ^Button       ^Input          ^
@@ Line 173: / Line 169: @@
 {{:wiki:vivebrake.jpg?300|}}
-^Function     ^Button           ^Input        ^
+^Function     ^Button              ^Input              ^
-|Brakes       |Left Analog Down |Pressure Sensitive |
+|Brakes       |Left Analog Down    |Pressure Sensitive |
-|Raw (Rudder) |Left Analog L/R  |Pressure Sensitive |
+|Raw (Rudder) |Left Analog L/R     |Pressure Sensitive |
+|Throttle     |Left Analog U/D FULL|Pressure Sensitive |
 **Yoke/Stick Control**