User Tools

Site Tools


sdk:aircraft:tutorial

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
sdk:aircraft:tutorial [2020/05/10 21:03]
jh
sdk:aircraft:tutorial [2020/05/10 21:23] (current)
jh [Installing the Aircraft-SDK]
Line 3: Line 3:
 On this page we will briefly guide you through the first steps in the aircraft development. We will download and install the Software Development Kit ([[sdk:​intro|SDK]]) and demonstrate how to export and convert the example Robin DR-400 aircraft from the SDK. After completing the following steps you will have the Robin DR-400 installed as a reward so to say. On this page we will briefly guide you through the first steps in the aircraft development. We will download and install the Software Development Kit ([[sdk:​intro|SDK]]) and demonstrate how to export and convert the example Robin DR-400 aircraft from the SDK. After completing the following steps you will have the Robin DR-400 installed as a reward so to say.
  
-===== Installing ​the Aircraft-SDK ===== +**This tutorial requires ​the Aerofly FS Aircraft Converter as well as the DR400 example aircraft** 
- +Please ​check out our [[sdk:​intro|SDK ​introduction]] for more information.
-Download the SDK Tools from the [[https://​www.aerofly.com/​community/​filebase/​index.php?​category-file-list/​3-aerofly-fs-2-sdk/​|Aerofly FS 2 SDK website]]. The download is free, all we require is an email for registration. After registration there may be a delay until we approved all new users. It usually takes less than a day or two before you see the download button. After the download has been completed, run the **aerofly_fs_2_sdk_setup.exe** installer and follow its steps. ​Please ​note the installation path chosen here because all the SDK content will be extracted to this SDK-folder. +
- +
-From that [[sdk:​intro|SDK]] ​folder go into the ''​aerofly_fs_2_content_converter''​ folder and execute the **aerofly_fs_2_content_converter.exe**. This will install the Content Converter which we will need later. +
- +
-The SDK also provides a lot of plugins ​for the [[sdk:​aircraft:​modelling#​supported_modelling_tools|supported modelling programs]]Those are included in the ''​plugins''​ folder in the SDK folder. Please pick the right one for your modeling program of your choice and install it in the usual way. +
 ===== Exporting the DR-400 ===== ===== Exporting the DR-400 =====
  
sdk/aircraft/tutorial.txt · Last modified: 2020/05/10 21:23 by jh