Just found out about the 777 tutorial: I didn't look at the 77 before but it seemed a nice challenge so I decided to go for it. But I am stuck immediately. I can't enter runway 25 into the CDU. I entered KDEN on the POS INIT page, went to the RTE page and it showed this already:
So I didn't have to enter KDEN at all as the tutorial says. But anyway, I tried to overwrite the default 16R with 25 but I just can't get it done. It doesn't work. So I am stuck after about 2 steps already LOL
Any idea how to get this done? According to the tutorial I simply should be able to enter 25...?
EDIT
I tried to select the runway from the DEP/ARR page but it's completely empty... no runways to select from at all.
EDIT 2
In order to not waste timing waiting for the answer I decided to skip the CDU part and set up the flight on the AFS2 Navigation page. I noticed the tutorial says: 'Click on San Francisco on the map, select ILS 26L for the arrival.' That should be 'Click on San Francisco on the map, select ILS 28L for the arrival.'
EDIT 3
When the tutorial tells you to turn on the LAV and VNAV, shouldn't you also turn on the A/T...? The tutorial seems to be missing that step...? Further on the tutorial seems to indicate the A/T should have been on ('Monitor how the autothrottle advances the thrust').
EDIT 4
How do you actually turn on A/T...? I teleported my plane as described in the tutorial and noticed speed went up higher and higher during descent. I then by accident pressed the IAS button and the A/T light went on. But speeds are going higher and higher and the IAS window shows 750...? BTW During take off I already thought something was wrong because I had to move the throttle manually. I only ARMED the A/T, apparently. Any info on how to actually and properly put A/T on would be appreciated.
EDIT 4
Okay, speeds went too high, flight aborted. I really can't figure out how to work with the A/T... It seems the tutorial misses a few steps regarding A/T? Back to the Q400 or Arrow it is for now.