- Official Post
We haven't changed them at all and it looks normal to me.
Depending on the environment you are in the light switches reflect the outside scenery. So if you go to a different location it may look a bit different.
We haven't changed them at all and it looks normal to me.
Depending on the environment you are in the light switches reflect the outside scenery. So if you go to a different location it may look a bit different.
Another bug I discovered was at Teterboro Airport (KTEB) in New York. As soon as the runway is cleared on the last taxiway near runway 24, the aircraft sinks to the ground.
Another bug is that the nav lights of the F18 are in the air when you fold the wings
Thanks, this has been fixed internally but the update has not been published yet.
Thanks, this has been fixed internally but the update has not been published yet.
Could you please fix also the landing behaviour of the Sopwith Camel? It lands regularly, but if it bank on the left side it results in a crash detection. May be the hit box of the 3D model on that side has gone wrong…
Could you please fix also the landing behaviour of the Sopwith Camel? It lands regularly, but if it bank on the left side it results in a crash detection. May be the hit box of the 3D model on that side has gone wrong…
Is this with the rudder assistance on or off?
Is this with the rudder assistance on or off?
Auto rudder is off.
Is this with the rudder assistance on or off?
You can test it by yourself. Every assistance is off for me. Land it on asphalt or on grass, or try to taxi anywhere. At low speed it begins to turn and it then results in a crash when left side touch (gently) the ground. I think that there is something wrong in the hitbox…
Try it with assistance on, this should help with taildraggers.
Try it with assistance on, this should help with taildraggers.
No, it doesn't work with the Red Baron either. It doesn't work properly with the tilt sensor settings either.
Try it with assistance on, this should help with taildraggers.
No, I think that it has a flow in the hitbox. With the Fokker DR I and the Pitts Special, both taildraggers, this issue do not happens.
Try it with assistance on, this should help with taildraggers.
And it happens also with the rudders assistance on. Please, when you can, try it yourself.
Jet-Pack (IPACS) The normal color is dark brown and not gray. If you have any doubts about this, take the overhead of the 747 from Aerofly 2023 and compare it with the same 747 from FS Global and you will notice the difference in colors of these same light switches. Also the name of the taxi light switch is erased.
Again the gray color is not the actual color of the Boeing 747-400 light switches. This is a bug that unfortunately left the switches this strange color.
The missing text had been reported before, thanks.