Already fail with FSET

  • I already fail with FSET.

    I have created two folders:

    - FSEarthTiles\Scenery

    - FSEarthWork\Work


    Then I have chosen in the tool FSET a small part of the island Elba for test purposes. Everything seemed to run smoothly and finished with a 'done'. However I could not find any images (assume they should be in the Scenery folder). I have seen that this can happen if one does not define a folder, however I have defined 2 folders. I run this on a laptop and no flight simulator is installed, I am on the road and have some spare time and I wanted to start with FSET and then continue over the weekend at home with the image files and the geoconvert tool.

    Best regards,

    Thomas


    i7-6700K @ 4.0 GHz, Geforce GTX 1080, 32MB RAM, 500 GB SSD, 1 TB SSD, 1TB HD, 32" Monitor 4K, Oculus Rift

  • Thank you - but this is what I already did. I just want to use the FSET tool and only later the geoconvert tool.

    Best regards,

    Thomas


    i7-6700K @ 4.0 GHz, Geforce GTX 1080, 32MB RAM, 500 GB SSD, 1 TB SSD, 1TB HD, 32" Monitor 4K, Oculus Rift

  • Yes, i even changed it in the ini file. There are a couple of files and a cache folder in the work folder after the tool ran. But no images. I test it with a small aerea only and very few images. It is late here already, i will check tomorrow again. Thanks for your help.

    Best regards,

    Thomas


    i7-6700K @ 4.0 GHz, Geforce GTX 1080, 32MB RAM, 500 GB SSD, 1 TB SSD, 1TB HD, 32" Monitor 4K, Oculus Rift

  • Everything fine now. Thank you for your help Stringer. I just geoconverted a small part of the italian Island Elba. The aerial photos are not very good but that is another issue.

    Best regards,

    Thomas


    i7-6700K @ 4.0 GHz, Geforce GTX 1080, 32MB RAM, 500 GB SSD, 1 TB SSD, 1TB HD, 32" Monitor 4K, Oculus Rift