RC8 (Mac version) will not start with SPMWS1000 already plugged into USB port. However, after starting RC8 without SPMWS1000 being plugged-in you can attach the SPMWS1000 and use it without problem.
Any ideas about this ?
RC8 (Mac version) will not start with SPMWS1000 already plugged into USB port. However, after starting RC8 without SPMWS1000 being plugged-in you can attach the SPMWS1000 and use it without problem.
Any ideas about this ?
I just noticed this post. My Spektrum SPMWS1000 USB dongle has not been unplugged in a couple years. I upgraded from RC7 to RC8 with no problem.
Is the dongle bound to your transmitter?
I believe you can plug in after starting. Did it once with RC7.
After binding, how do you configure the Spectrum? What is the step by step procedure. I can't successfully perform the "move every stick, slider, and switch" routine. I always get a "no movement detected in (one of the switches)"? Then the program asks if I want to correct or accept the default setting. Neither approach leads to a successful transmitter to software configuration .