If I enter a flight plan in the UNS-1, it implements a VNAV profile automatically, right? I gave it arrival information as a runway. In my attempt it did not descend automatically when approaching the runway. Also, is it supposed to intercept the ILS localizer and glide slope by tuning to the frequency automatically?
737-500 flight plan and VNAV
-
- Official Post
To descent automatically you need to select a lower altitude first and then you can push the VNAV (FMS) button on the autopilot mode control panel (MCP)
You can program the entire route using the Aerofly FS 2 navigation menu as well. When you are in the sim the old 737 does not automatically tune the frequencies if I remember correctly. You may have to manually set the NAV1 frequency in the pedestal and CRS on the MCP.
In Aerofly FS 4 we added an assistance feature for this, that automatically tunes the frequency even if the aircraft itself would not do that automatically.
-
In Aerofly FS 4 we added an assistance feature for this, that automatically tunes the frequency even if the aircraft itself would not do that automatically.
Thanks, this was with Aerofly 2023
-
- Official Post
oh, wrong subforum then.
Aerofly FS 2023 has the same assistance as Aerofly FS 4.
-
Jet-Pack (IPACS)
August 7, 2023 at 8:24 PM Moved the thread from forum General discussions to forum Mobile Discussions. -
- Official Post
There is a tutorial available:
-
There is a tutorial available:
Thanks much!
-
NeverMind, I kept tapping buttons on the MCP and now I have SPD and FMS on let’s see how it goes
interesting that the FMA did not show anything , and the approach mode didn’t work even though I had an approach programmed in the FMC. That being said , the autopilot flew well enough until I turned it off at the threshold
