Hi,
PC, MAC or Linux ?
hi,
if your transmitter connected via USB is recognized as a game controller under Windows, it works perfectly.
For more freedom, you can connect a receiver to an Ikarus dongle in PPM, as I do.
For my old Graupner MC18, whose receiver does not have a PPM output, I bought a small 8 channel to PPM converter.
As far as I know, openXR isn't directly supported, so you'll need steamVR.
But RC9/RC10 ist very nice under VR.
Greetings Hermann
Yes, at least with Steam version of Aerofly RC10, you can easily use your Pimax 8kx - it works perfectly, and it's a wonderful experience!! (would be perfect if Aerofly would let use the switches on our transmitters, as actually you need to take off the headset to see the keyboard...)
Yes, at least with Steam version of Aerofly RC10, you can easily use your Pimax 8kv - it works perfectly, and it's a wonderful experience!! (would be perfect if Aerofly would let use the switches on our transmitters, as actually you need to take off the headset to see the keyboard...)
Hello, do you have small micro wobbles?, I always have small wobbles with Quest 3 and Rtx 4080, no matter what I set.
Can confirm RC10 works with PC Standalone version with PIMAX 8KX (Standalone still uses the SteamVR engine which supports openXR)
Can confirm RC10 works with PC Standalone version with PIMAX 8KX (Standalone still uses the SteamVR engine which supports openXR)
Hello, do you have small micro wobbles?, I always have small wobbles with Quest 3 and Rtx 4080, no matter what I set.
No wobbles here, maybe it could be your TX deadzone? Check the cotroller settings page and see if any of the controlls are jittering.
Your question is a bit vague so it is hard to answer. Can you explain micro wobbles?
No wobbles here, maybe it could be your TX deadzone? Check the cotroller settings page and see if any of the controlls are jittering.
Your question is a bit vague so it is hard to answer. Can you explain micro wobbles?
small interruptions in the picture, mostly in the middle of the picture, fine image interruptions.
I have no jittering at controller settings.
Yes, I had similar "wobbles" at first, but got rid of them by tweeking parameters in PiTool: *maybe* it's "motion compensation" of something on that page!! That became butter smooth!!
Yes, I had similar "wobbles" at first, but got rid of them by tweeking parameters in PiTool: *maybe* it's "motion compensation" of something on that page!! That became butter smooth!!
Thanks, I have Quest 3 and no PITool. Yes, maybe it is motion compensation.
HRa
I just had something similar to this while changing settings.
Try turning off "hidden area mask" in Pitool.
