Can anyone send tutorial of how to connect two points using mcdu. I have gone through all the videos of aerofly but when you open aerofly and open navigation and then you put ORG , DEP , APP ,ARR, Destination. When you put points on Dep and ARR , then there is no continuous line . Flight (autopilot) will travel till Dep point but after that the plane does not arrive to destination. So how do I program in mcdu two meet two points. What is solution ??
How to connect points using mcdu while there is no continuous line
-
- New
- Official Post
Press the clear key on the MCDU and remove the line DISCONTINUITY from the flight plan page.
-
Press the clear key on the MCDU and remove the line DISCONTINUITY from the flight plan page.
I have insert point on DEP and ARR , the last point of DEP is Licke and starting point of ARR is Harna which is two different points , now if I travel from starting to end the flight will travel till licke after that it will not reached to destination. Also there is no discontinuity in mcdu. What is solution?
-
- New
- Official Post
These segments are probably encoded as manual or ATC assigned directions in the database. You can fly them using the autopilot heading mode.
-
These segments are probably encoded as manual or ATC assigned directions in the database. You can fly them using the autopilot heading mode.
I m actually confused.. can you brief a little more.. m using auto pilot mode only. How to activate autopilot heading mode.
-
- New
- Official Post
Just pull the heading knob towards you. Tap on it and pull the green center down.
We describe the operation of the autopilot in our tutorial:
-
Just pull the heading knob towards you. Tap on it and pull the green center down.
We describe the operation of the autopilot in our tutorial:
That I have already pull that knob and turn on everything as mentioned in that but flight does not move to the destination 😕
-
Can anyone help me with this??
This plan works for me without any problems. Take a close look at the screenshots from the autopilot. However, the actual landing is done manually with this flight plan.
Or leave out the CAP03 and do an ILS landing 🤷
These segments are probably encoded as manual or ATC assigned directions in the database. You can fly them using the autopilot heading mode.
In this plan, the flight is carried out from start to finish without changing the autopilot. Only the actual landing is done manually as no ILS is used. The plan is interrupted but it will still be completely flown away.👍🖖
