Creating a TSC file?

  • I have notepad on my computer and have been opening my TSC file with it, not sure if it's the same version as the link you showed me but I tried doing it with wordpad but same issue, it gives me the option to copy but not paste, not sure what I'm doing wrong here😎😊

  • I'm not sure if I understand you right..

    Do you try to paste the content of the TSC file into a folder?

    That is not right, you have to put the TSC file in that folder.

    Or is it impossible to paste into the TSC file?

    Wordpad is not good, Notepad is not good, try Notepad++

  • No I can easily make the required changes to the TSC file but after I've done that I've set up a folder inside "Places" like it says in the tutorial then trying to copy and paste the contents of the TSC file into it but it won't paste, I will try as you said and just move the whole TSC file into "Places" instead of trying to copy and paste the contents


  • It does not show.

    Make a subfolder in 'Plases' name it "ehmz_middenzeeland"

    Thats the ICAO code, then an underscore, then the name of you airport.

    Al lowercase. No spaces. Put you tsc file in that folder and

    also give your tsc file the same name.

    Restart FS2 :)

  • Ok Dree something has now showed up but Ive made an error in my coordinates, my runway is several kilometres long and not quite center lol,

    I notice that in the tutorial that the -/negative coordinates are on the right hand side is this the right way to go? well at least something has shown up and that came about by changing the file names :)

  • That went well, now to not forget I made a second an third airport, the third had two runways so I expanded the tsc with

    endpoint 3 and 4, also threshold an name, that was wrong, you have to copy and paste the whole section and give the

    runway element number 1, were the first runway is 0, looks like this:



    <[vector2_float64][endpoint1][4.9499577 51.5653731]>

    <[vector2_float64][endpoint2][4.9136835 51.5694479]>

    <[vector2_float64][threshold1][4.9499577 51.5653731]>

    <[vector2_float64][threshold2][4.9136835 51.5694479]>












    <[vector2_float64][endpoint1][4.9417555 51.5718752]>

    <[vector2_float64][endpoint2][4.9337304 51.5565688]>

    <[vector2_float64][threshold1][4.9417555 51.5718752]>

    <[vector2_float64][threshold2][4.9337304 51.5565688]>