Dear Jet-Pack (IPACS), admin,
Is it possible to assign the C90 condition levers to controller axes? For example, the mixture axes of the Bravo Throttle Quadrant. If there is, I can't seem to find it.
Thanks,
Karl
C90 condition levers axis assignment
-
plovdiv74 -
May 18, 2023 at 5:35 PM -
Thread is marked as Resolved.
-
-
- Official Post
Yes, please go to Controls, Mutli-Engine, Twin Prop and assign your mixture lever.
-
Hi Jan,
Thanks for your reply.
The Bravo Throttle Quadrant axes are, from left to right, Y, X Rz, Ry, Rx, and Z. My assignment settings are, left to right, throttle 1, throttle 2, Propeller Speed 1, Propeller Speed 2, Mixture 1, and Mixture 2. (See attached screenshot.)
These settings work fine in the B58.
No luck in the C90 - throttle and prop work fine; condition doesn't move.
I have AFS4 version 4.03.01.08 (20230517), beta_v4030x0x.
The workaround is to use the right mouse button. Not great but works.
Thanks again.
Best,
Karl
-
Are the locked out Dash 8 engine RPM controls really necessary?
(Jan the Dash 8 does not respond to rpm/propeller pitch joystick inputs. I have a pair of momentary up and down switches mapped as increase and decrease rpm/propeller pitch. It works perfectly with other complex propeller planes. The Dash 8 needs mouse drag inputs to change engine rpm.
Are you confused by what I meant or does the (non) smilie mean disapproval?).