Sorry for the new thread, but looking through the others, I could not find a concise answer. It was talked about at length, but I am not sure if anything was resolved, or if I just missed it.
I have not had a chance recently to do scenery, but I did a total of an area about 100nmx100nm. I did it in segments. When flying some segments stay at the low default resolution until I am just about on top of them, then they pop in with the custom scenery I made. It is kind of annoying, and reduces the realism factor. It is very noticeable as the default scenery is much more brown, and then goes to bright green.
I have not seen this in any of the IPACS made scenery, so I figure it is something I did wrong. I recall others seeing it as well.
Was there ever a consensus as to the cause and a fix?