HI,
I just both FS4 simulator and i need to use the aircraft Tecnam P2008 that i found here https://flight-sim.org/filebase/index…4-tecnam-p2008/ for Fs2.
I downloaded the Fs4 aircraft converter i tried to run it selecting the aircraft folder but doesn't do anything.
Someone can help me to perform the conversion from FS2 to FS4 of Tecnam P2008 aircraft model?
I was looking but i didn't find any information about and the last post is related to Tecnam 2008 project in date 2020.
Thanks in advance
Vittorio
Tecnam 2008 project for FS4 --> Conversion from Fs2 to Fs4 not run using Fs4 aircraft converter
-
Vittorio -
February 29, 2024 at 2:00 PM -
Thread is marked as Resolved.
-
- Official Post
The aircraft converter converts raw model files into the engine format for Aerofly FS 4. There is no converter that converts Aerofly FS 2 to Aerofly FS 4. You need the original files not the already converted files.
-
Did you receive an answer to your question?
Because unfortunately on this forum, most remain without answers. -
Master Jan did answer the question.
To covert the model to FS4 you need the original modelling files and not the FS2 converted aircraft files. Files like .tgi and the original bitmaps, in something like .bmp or .png.
-
Steve, I wasn't talking about Jan response, or should I have been more specific? But the response from its author, among others Sylvain. THANKS
-
No problems, You grab one end of the stick, I'll grab the other and we'll meet in the middle
