Hello,
Since last update when I disengage autopilot the aircraft turns left and nose goes down very abruptly. I tested with the C172 and the Baron which use the same AP if i remember correctly.
Hello,
Since last update when I disengage autopilot the aircraft turns left and nose goes down very abruptly. I tested with the C172 and the Baron which use the same AP if i remember correctly.
We didn't change anything on the autopilot, so this must be something different.
Do you mean the autopilot in the cockpit itself (the small black box)? Or are you reffering to the overlay in the lower left of the screen, because those are two completely different things now.
err, CP in the lower right.
Regards,
Ray
Ok and you're pressing which button exactly?
This button
[Blocked Image: http://fsfiles.org/flightsimshotsv2/images/2018/02/26/autopilot.jpg]
Hi Sylvia, thanks. And are you flying 2d or in virtual reality?
I'm flying 2d.
BTW, the throttle lever on my CH Eclipse yoke needs to be pushed about 50% forward before the aircraft reacts. This is also since last update, in each aircraft except the Robin DR400 which is not updated yet.
Were any changes made to the flight model of the Cessna?
Were any changes made to the flight model of the Cessna?
None. If you are using the cold and dark mod though it needs to still be updated so you should remove it for now.
OK. I was just thinking it felt a little more "slippery" in turns, but it was probably just my lack of current familiarity with the stock version.
I noticed my Saitek TPM throttle will only provide 91% at full throttle now. It has been showing 100% prior to the update. The first half of the throttle movement does not show any % at all.
I probably need to find out where and how to calibrate the throttle, mixture, and prop.
Anyone know?
Regards,
Ray
I noticed my Saitek TPM throttle will only provide 91% at full throttle now. It has been showing 100% prior to the update. The first half of the throttle movement does not show any % at all.
I probably need to find out where and how to calibrate the throttle, mixture, and prop.
Anyone know?
Regards,
Ray
That is a known issue, try moving your throttle axis all the way back to idle and then to full power again.